Jura E4 - Maintenance; Inserting;changing the filter

7 Maintenance
19
7 Maintenance
Your E4 has the following integrated maintenance programmes:
U
Cleaning the machine (L)
U
Descaling the machine (&)
E If a maintenance programme needs to be started, the appro-
priate symbol lights up� If this happens, run the appropriate
maintenance programme�
Once the filter cartridge stops working (depending on the water
hardness setting), the E4 will prompt you to change the filter�
E Your E4 no longer has to be descaled if you are using the
CLARIS Smart filter cartridge�
E CLARIS Smart filter cartridges are available from specialised
dealers�
Precondition:Your E4 is ready for use� The filter symbol ! lights
up (if you are already using a filter and the filter capacity is
depleted)�
T
 Remove and empty the water tank�
T
 Turn the filter cartridge anticlockwise and remove it along with
the extension from the water tank�
T
 Fit the filter cartridge extension on top of a new CLARIS Smart
filter cartridge�
T
 Insert the filter cartridge with its extension into the water tank�
T
 Turn the filter cartridge clockwise until it audibly clicks into
place�
T
 Fill the water tank with fresh, cold water and reinsert the tank�
The machine automatically detects that you have inserted/
changed the filter cartridge�
The sss £ symbols flash from right to left to indicate that
you need to open the switch for hot water preparation�
T
 Place a receptacle under the hot-water spout�
T
 Turn the switch to the
x
position�
The filter is rinsed� Water flows out of the hot-water spout�
Rinsing of the filter stops automatically� The sss £ symbols
flash from left to right�
T
 Turn the switch to the
°
position�
The ü symbol lights up�
T
 Empty the drip tray and coffee grounds container and put them
back into the machine�
Inserting/changing the filter