4
E6/E60 – Quick Reference Guide
‘Milk system is being cleaned’ appears and the fine foam fro-
ther and the milk pipe are rinsed with fresh water.
‘Switch close’
T Turn the switch to the ° position.
The start screen is displayed.
To make sure the fine foam frother works properly, and in the inte-
rests of hygiene, it must be dismantled and rinsed daily if you have
been preparing milk. Your JURA will not prompt you to dismantle
and rinse the frother.
T Remove the milk pipe and rinse it thoroughly under running
water.
T Carefully remove the fine foam frother from the Connector
System
©
by twisting slightly.
T Dismantle the fine foam frother into its individual parts.
T Rinse all the parts under running water. If there are severely
dried-on milk residues, firstly immerse the individual parts
in a solution of 250 ml cold water and 1 capful of JURA milk
system cleaner. Then rinse the parts thoroughly.
T Re-assemble the fine foam frother.
E Ensure that all individual parts are correctly and firmly
connected to ensure optimum operation.
T Firmly attach the fine foam frother to the Connector
System
©
.
Your JURA no longer has to be descaled if you are using the CLARIS
Smart filter cartridge. If you did not insert the filter cartridge the first
time you used the machine, you can do this now as follows.
Precondition: The start screen is displayed.
T Remove and empty the water tank.
T Fit the filter cartridge extension supplied on top of a CLARIS
Smart filter cartridge.
Dismantling and rinsing
the fine foam frother
Inserting the filter
To Next Page
Loading...
Need help?
General
Weight and Dimensions
