7
E6/E60 – Quick Reference Guide
T Rinse off the descaling agent with clean water. Should you get
any descaling agent in your eye, see a doctor.
If the wrong descaling agent is used, the machine could be dama-
ged and/or traces could be left behind in the water.
T Use only original JURA maintenance products.
If the descaling operation is interrupted, there may be damage to
the machine.
T Allow the descaling programme to run to the end.
If the descaling agent comes into contact with sensitive surfaces
(e.g. marble), damage cannot be ruled out.
T Clean up any splashes immediately.
E The descaling programme lasts approximately 40 minutes.
E JURA descaling tablets are available from specialised dealers.
Precondition: ‘Decalcify machine’ is displayed.
T Press the ‘ c ’ button (red Maintenance symbol).
‘Descale’
T Press the ‘Start’ button.
T Press the ‘Next’ button.
‘Empty drip tray’
T Empty the drip tray and coffee grounds container and put
them back into the machine.
‘Agent in tank’
T Remove and empty the water tank.
T Completely dissolve the contents of one blister (3 JURA des-
caling tablets) in a receptacle holding 500 ml of lukewarm
water. This may take several minutes.
T Pour the solution into the empty water tank and insert it into
the machine.
‘Switch open’
CAUTION
CAUTION
CAUTION