Jura ENA Micro 1 Series - Decalcification Procedure; Product and Coffee Settings; Coffee Water Volume Adjustment; Coffee Flavour and Aroma Strength

Elektroapparate AG
Technical information
Technical Support
Language
EN
ENA Micro 1
Author: Patrik Studer
Checked:
Approved:
Docu.-name: Technische_Informationen_ENA_Micro_1_EN.doc
L:\Geräte\ENA_Micro\ENA_Micro_1\Schulungsunterlagen\E\
Technische_Informationen_ENA_Micro_1_EN.doc
Date:
Rev. A:
Rev. B:
Rev. C:
Rev. D:
Rev. E:
Rev. F:
09.05.2012
19.09.2012
Page 7/10
13 Decalcification:
 After reaching the programmed amount of water, according to the water hardness level, the display
shows ( )
 Manual Descaling start by touching ( & ) for approximately 2 seconds and then
Descaling symbol ( ) for approximately 2 seconds
Water
hardness level
°dH
AQUADUR
°dH
Liters
Message
(When reached the amount of water)
0 = not possible
1 ... 15
5 ... 15
100
16 ... 23
15 ... 20
60
24 ... 30
20 ... 25
40
(No acoustic warning)
 Setting of water hardness level by touching ( & ) for approximately 2 seconds.
Choice of level by touching corresponding cup (Ristretto or Espresso or Coffee).
Confirm with touching symbol ( ).
Conversion factors:
1 °dH = 1.25 °e = 17.86 ppm (CaCO
3
) = 1.78 °f
14 Products:
 Only 1 Cup products possible
 No Steam or Hot water product possible
14.1 Coffee water:
 Programmable with Long Press
Amount Coffee: 25 ml ... 240 ml (0.5 oz ... 8.0 oz)
14.2 Coffee flavour, aroma strength:
 Possibility to choose the flavour before a draw off by touching the
symbols NORMAL or STRONG and during the grinding process (also backwards).
Flavour
Grinding time grinder Aroma+
NORMAL
2.7 sec.
STRONG
3.4 sec.
 Place only 1 level measuring spoon of ground coffee into the filler funnel (due to overfilling)