Jura ENA Micro 1 Series User Manual

Elektroapparate AG
Technical information
Technical Support
Language
EN
ENA Micro 1
Author: Patrik Studer
Checked:
Approved:
Docu.-name: Technische_Informationen_ENA_Micro_1_EN.doc
L:\Geräte\ENA_Micro\ENA_Micro_1\Schulungsunterlagen\E\
Technische_Informationen_ENA_Micro_1_EN.doc
Date:
Rev. A:
Rev. B:
Rev. C:
Rev. D:
Rev. E:
Rev. F:
09.05.2012
19.09.2012
Page 8/10
14.3 Temperature:
 Fix HIGH
 Draw off temperature is measured at the outlet and is, depending on settings, between
82 °C ... 89 °C (179 °F ... 192 °F)
 In the range of < 80 ml, an intelligent heating system comes to action which is able to remember
the time of the last product taken. Therefore, at the beginning of a draw off it will heat up slightly
higher in temperature to compensate the loss.
15 CLARIS filter:
 Activate Filter by touching ( & ) for approximately 2 seconds and then
Filter symbol ( ) for approximately 2 seconds
16 Energy Safe Mode, ESM:
 Fix enabled
 Thermoblock switches off after 5 minutes, after the last draw off (~4.0 Wh)
pictograms lights less bright
 Stand-by power: 0W
17 Automatic switch off time:
 Fix 2 hours
18 Automatic Rinses:
 Switch on/off rinses is always enabled
19 Empty system completely (frost protection):
1. Precondition: Your ENA is ready for use
2. Touch the NORMAL & STRONG symbols for approximately 2 seconds
3. Remove and empty the water tank
4. Touch the symbol ESPRESSO
5. Hot water will continue to flow until the system is empty and symbol WATER TANK lights up
6. Press the On/Off button to switch the machine off

Jura ENA Micro 1 Series Specifications

General

Type	Automatic Coffee Machine
Model	ENA Micro 1
Water Tank Capacity	1.1 L
Bean Container Capacity	125 g
Pump Pressure	15 bar
Power	1450 W
Voltage	230 V
Weight	8.8 kg
Height	32 cm
Width	23 cm
Depth	44.5 cm
Programmable	Yes
Milk Frother	No
Display	No
Frequency	50 Hz
Color	Black