Jura ENA Micro 1 Series - Service Connector (1 st Generation); Key Combinations for Functions; Reset to First Use (Initialization); Reset to Factory Settings

Elektroapparate AG
Technical information
Technical Support
Language
EN
ENA Micro 1
Author: Patrik Studer
Checked:
Approved:
Docu.-name: Technische_Informationen_ENA_Micro_1_EN.doc
L:\Geräte\ENA_Micro\ENA_Micro_1\Schulungsunterlagen\E\
Technische_Informationen_ENA_Micro_1_EN.doc
Date:
Rev. A:
Rev. B:
Rev. C:
Rev. D:
Rev. E:
Rev. F:
09.05.2012
19.09.2012
Page 4/10
1.2 Service connector, 1
st
generation:
 Push with a small screw driver (No. 0) into both slots, between side- and front panel, to release the
interlock and pull top cover up to remove it
 Support by pushing with finger from above
2 Key combinations:
2.1 Reset to “first use” (Fill system, Initializing):
 Precondition: Your ENA is ready for use
 Touch the NORMAL & STRONG symbols for approximately 2 seconds
 Remove and empty the water tank
 Touch the symbol ESPRESSO
 Hot water will continue to flow until the system is empty and symbol WATER TANK lights up
 Remove drip tray and coffee grounds container
 Open cover for powder chute for ground coffee
 Touch the symbol ESPRESSO
 All symbols lights up 3 times
 Appliance switches off automatically
2.2 Reset to factory settings:
 Precondition: Your ENA is ready for use
 Touch the NORMAL & STRONG symbols for approximately 2 seconds
 Remove and empty the water tank
 Touch the symbol COFFEE
 All symbols lights up 3 times
 Appliance switches off automatically
Service connector
Verriegelung Interlock