Jura ENA Micro 1 Series - Machine Display and Interface; Grinder with Aroma+ Feature; Component Monitoring Details; Aroma Preservation Lid Monitoring

Elektroapparate AG
Technical information
Technical Support
Language
EN
ENA Micro 1
Author: Patrik Studer
Checked:
Approved:
Docu.-name: Technische_Informationen_ENA_Micro_1_EN.doc
L:\Geräte\ENA_Micro\ENA_Micro_1\Schulungsunterlagen\E\
Technische_Informationen_ENA_Micro_1_EN.doc
Date:
Rev. A:
Rev. B:
Rev. C:
Rev. D:
Rev. E:
Rev. F:
09.05.2012
19.09.2012
Page 5/10
3 Display:
 Touchscreen with pictograms and ergonomic finger depressions
4 Grinder with Aroma+:
 Precision grinder, 5 grinding degrees
5 Bean container:
 Capacity 125 g
6 Brewing unit Micro:
 Is approximately 3 cm lower in height compared to the standard brewing unit
 Maximum coffee powder capacity is lower than the standard brewing unit
7 Monitoring:
7.1 Aroma preservation lid:
 Checked by a micro switch ( )
 With a UV protection and silicon seal
7.2 Powder funnel surveillance:
 Checked by a micro switch ( )
 Place 1 level measuring spoon of ground coffee into the filler funnel (due to overfilling)
 When not drawing off a product then the powder will be wetted and pushed down into the grounds
container after 1 min.
 Timeout of 1.5 sec. until powder draw off is enabled
7.3 Water tank:
 Monitored with a floater ( )
 Capacity 1.1 liters
7.4 Grounds container:
 Tray of the residual water container is checked by a micro switch ( )
 After max. 10 portions (flavour MILD), the message ( ) shows up
7.5 Residual water container:
 Not monitored
 Capacity 0.8 liter