Jura ENA Micro 1 Series User Manual

Elektroapparate AG
Technical information
Technical Support
Language
EN
ENA Micro 1
Author: Patrik Studer
Checked:
Approved:
Docu.-name: Technische_Informationen_ENA_Micro_1_EN.doc
L:\Geräte\ENA_Micro\ENA_Micro_1\Schulungsunterlagen\E\
Technische_Informationen_ENA_Micro_1_EN.doc
Date:
Rev. A:
Rev. B:
Rev. C:
Rev. D:
Rev. E:
Rev. F:
09.05.2012
19.09.2012
Page 9/10
20 Prepare appliance for resale:
Procedure:
All products will be reset to factory settings and the fluid system is empty due to protection against frost.
The appliance asks the customer for Filter YES/NO and afterwards it will fill the system with water.
Initial position:
The appliance is fully working and if necessary, an exit diagnosis has been made with the animation system.
20.1 Hint, if the animation system will be used:
If the appliance will be serviced with the animation system, just start 2x one after the other an entry
diagnosis. The customer settings will be then overwritten with the factory settings.
After the exit diagnosis will the “first use bit” set anyhow and therefore no further procedures are necessary
anymore (see chapter 20.2 ).
20.2 Procedure without animation system:
Set factory settings:
 Precondition: Your ENA is ready for use
 Touch the NORMAL & STRONG symbols for approximately 2 seconds
 Remove and empty the water tank
 Touch the symbol COFFEE
 All symbols lights up 3 times
 Appliance switches off automatically
Set First use bit:
 Precondition: Your ENA is ready for use
 Touch the NORMAL & STRONG symbols for approximately 2 seconds
 Remove and empty the water tank
 Touch the symbol ESPRESSO
 Hot water will continue to flow until the system is empty and symbol WATER TANK lights up
 Remove drip tray and coffee grounds container
 Open cover for powder chute for ground coffee
 Touch the symbol ESPRESSO
 All symbols lights up 3 times
 Appliance switches off automatically

Jura ENA Micro 1 Series Specifications

General

Type	Automatic Coffee Machine
Model	ENA Micro 1
Water Tank Capacity	1.1 L
Bean Container Capacity	125 g
Pump Pressure	15 bar
Power	1450 W
Voltage	230 V
Weight	8.8 kg
Height	32 cm
Width	23 cm
Depth	44.5 cm
Programmable	Yes
Milk Frother	No
Display	No
Frequency	50 Hz
Color	Black