2
ENGLISH
If your receiver is equipped with Line Output, connect as in A. If your receiver is NOT equipped
with Line Output, connect as in B.
CONNECTIONS
CAUTIONS
To prevent short circuits while making connections, keep the battery’s negative terminal
disconnected.
• When using a power cord (purchased separately), be sure to place the 30 A fuse near the
battery as shown.
• Connect the lead wire (power cord) through which power is supplied directly to the battery’s
+ terminal only after all the other connections have been made.
The proper lead wire connected to each POWER terminal is as follows.
• + B and GND: cross section of more than 8 mm
2
• REM: cross section of 0.5 mm
2
to 1 mm
2
A
B
Line output of
receiver
Remote output wire of receiver
Gray
Left (b)
Left (a)
Right (b)
Right (a)
Connect to battery “+“.
Screw (not supplied)
Connect to the metallic body (chassis and so on)
of the car.
Gray / Black
White
White / Black
30 A fuse
(not supplied)
Speaker input connector
(supplied)
Audio cord
(not supplied)
Speaker output of receiver
Insulation tape (supplied)
After connection ,wrap the
insulation tape around the
terminals.
CS-BGS5120_EN.book Page 2 Monday, May 14, 2007 8:37 PM
To Next Page
Loading...
