1
ENGLISH
Mount this unit on a firm surface, such as on the floor.
• Since heat is generated in this unit, do not mount near flammable objects. In addition, mount in an
area that will not prevent the unit from dissipating heat.
Install this unit with the supplied screws.
INSTALLATION
CAUTIONS
• When mounting this unit, be sure to use the screws provided. If any other screws are used,
there is a risk of loosening the unit or damaging internal parts.
Before drilling holes on the floor to install the unit, make sure that there is a sufficient space
under the floor so that you do not drill holes in the fuel tank, etc.
This unit generates a strong magnetic field. Never place cassette tapes or magnetic cards
nearby the unit; otherwise, data recorded in those media will be erased.
Tapping screw (supplied)
ø4 mm c 16 mm
(Dia. 3/16 inch
c
21/32 inch)
Tapping screw (supplied)
ø4 mm c 16 mm
(Dia. 3/16 inch
c
21/32 inch)
Stay
Stay
Tapping screw (supplied)
ø4 mm c 16 mm
(Dia. 3/16 inch c 21/32 inch)
Tapping screw (supplied)
ø4 mm c 16 mm
(Dia. 3/16 inch
c
21/32 inch)
CS-BGS5120_EN.book Page 1 Monday, May 14, 2007 8:37 PM
To Next Page
Loading...
