13
ENGLISH
Getting Started Preparation Basic Operation Settings Troubleshooting Others
How to Use the Remote Control
z If the remote control has to be brought closer to the projector to operate, it means that the batteries are wearing out. When this
happens, replace the batteries. Insert the batteries according to the +- marks.
z Be sure to insert the - end first.
z If an error occurs when using the remote control, remove the batteries and wait for 5 minutes. Load the batteries again and
operate the remote control.
Loading Batteries
Effective Range of Remote Control Unit
When directing the remote control
toward this unit
z
When aiming the remote control towards the
remote sensor on this unit, ensure that the
distance to the sensor in front or at the rear of
this unit is within 7 m.
z If the remote control fails to work properly,
move closer to this unit.
When reflecting off a screen
z
Ensure that total of distance A between this
unit and screen and distance B between
remote control and screen is within 7 m.
z As the efficiency of signals reflected from the
remote control unit differ with the type of
screen used, operable distance may
decrease.
Remote Control
This unit
This unit
Remote Control
Screen
DLA-RS1_EN.book Page 13 Wednesday, January 24, 2007 9:23 AM
Downloaded From projector-manual.com JVC Manuals
To Next Page
Loading...
Need help?
General
