5
36
Troubleshooting
What to Do When These Messages
Are Displayed
Message Cause (Details)
No device is connected to the input terminal.
The input terminal is connected but there is no signal.
gInput the video signals.
A video signal that cannot be used in this unit has been input.
gInput video signals that can be used.
The message is displayed when the accumulated lamp time has exceeded
1900 hours.
To clear the message, press the [EXIT] button.
gGet ready a new lamp unit and replace as soon as possible.
The message is displayed when the accumulated lamp time has exceeded
2000 hours.
The message is displayed each time during projection.
To clear the message, press the [EXIT] button.
gReplace with a new lamp unit and reset the lamp time. (pP38f40)
COMP
No input
HDMI-2
Frequency of input signal is out of range.
EXIT
Lamp replacement
EXIT
Warning
Lamp replacement
DLA-RS1_EN.book Page 36 Wednesday, January 24, 2007 9:23 AM
Downloaded From projector-manual.com JVC Manuals
To Next Page
Loading...
