JVC DLA-X90R

Operation
69
ENGLISH
Pixel Adjust
Adjust(Fine)
Red
H －1 （－20/－20）
V 1
（ 5 / 5 ）
Color A.
G
AMMA
PIC.
COLOR.
COLOR.
Select
Operate
BACK
BACK
TEMP
P.FILE.
ADJ.
A. Area
Color P.
ADJUST.
Pixel Adjust
Whole Adjust (Fine)
Red
H －1 （－20/－20）
V 1
（ 5 / 5 ）
Color A.
G
AMMA
PIC.
COLOR.
COLOR.
Select
Operate
BACK
BACK
TEMP
P.FILE.
ADJ.
A. Area
Color P.
ADJUST.
Pixel Adjust
Whole Adjust (Fine)
Red
H －1 （－20/－20）
V 1 （ 5 / 5 ）
Color A.
GAMMA
PIC.
COLOR.
COLOR.
Select
Operate
BACK
BACK
TEMP
P.FILE.
ADJ.
A. Area
Color P.
ADJUST.
Vercital
H (Horizontal)
When both H (horizontal direction) and V (vertical direction) show a maximum overall screen error of 31,
HYHQLIWKHDGMXVWVHWWLQJLVOHVVWKDQWKLV\RXPD\QRWFRQ¿JXUHDQDGMXVWPHQWVHWWLQJWKDWLVODUJHUWKDQWKH
displayed setting. Furthermore, when the minimum overall screen error is -31, even if the adjust setting is
JUHDWHUWKDQWKLV\RXPD\QRWFRQ¿JXUHDQDGMXVWPHQWVHWWLQJWKDWLVODUJHUWKDQWKHGLVSOD\HGVHWWLQJ
This shows the maximum and minimum
overall screen error.(Max)/(Min)
Remote Control
Operation Guide
Adjust setting
Adjustments and settings in the menu (continued)
See Pixel Adjust Flow and Operation: Adjust(Fine)
$IWHUPDNLQJRYHUDOODGMXVWPHQWIRUHUURUDFURVVWKHHQWLUHVFUHHQSURFHHGWR¿QHWXQLQJ3UHVVWKH>&2/25
TEMP] button on the remote control to display the [Adjust(Fine) Window]. Also, from the main menu, set the
[Adjust Area] to [All] and select [Adjust Color] and [Adjust Pattern], then move the cursor to [Adjust (Fine)]
DQGSUHVVWKH>2.@EXWWRQRQWKHUHPRWHFRQWUROWRGLVSOD\WKHDGMXVWSDWWHUQDQGWKH¿QHWXQHZLQGRZ
(*) The range of adjustment may narrow depending on the adjust amount of the entire screen.
Adjust(Fine) window

Adjust Pattern
You can use the [UP], [DOWN],
[LEFT], and [RIGHT] buttons to
change position.
Pixel adj
ust setting
Adjust Color
Press the [OK] button on the remote control to enter the adjust operation mode. Use the [UP], [DOWN],
[LEFT], and [RIGHT] buttons to move and adjust pixels in the vertical and horizontal directions across the
entire screen. The adjustment settings appear in the center of the Adjust (Fine) window. Use the [BACK]
button to exit the adjust operation mode.
Adjust(Fine) window
(Reference page: 68)
http://www.pureglare.com.au