29
Recording From The Middle Of A Tape
When removing a tape on which you were recording, or when you resume recording on a tape after playing
back the recording previously made (without taking the tape out between recordings), perform this
procedure.
OFF
5S
REC
PLAY
STOP
PLAY
/PAUSE
PLAY
/PAUSE
FF
CAN.
REW
RE SHOOT
OFF
5S
REC
PLAY
RECORDING
START/STOP BUTTON
1
SELECT MODE
Set the Power Dial to “PLAY”.
2
START SEARCH
Press PLAY, then press REW or FF. Watch in the
viewfinder for the spot where you want to
begin recording.
3
ENGAGE STILL MODE
Once you find the spot at which you want to
start recording, press PLAY/PAUSE to engage
the Still mode.
4
START RECORDING
Set the Power Dial to “REC” and press
RECORDING START/STOP.
NOTES:
●
Starting at 00:00:00 (MIN:SEC:FRAME), the
camcorder records a time reference signal from
the beginning of the tape. See page 49 for
information about displaying Time Codes.
The video recording may not start from exactly
00:00:00.
●
The Time Code cannot be reset.
●
If you start recording from a blank portion in the
middle of the tape, the camcorder calculates the
approximate time code and records it. For this
reason, accuracy may suffer slightly during R.A.
Edit (
Z
pg. 54) and Snapshot Search (
Z
pg. 25).
●
If you start recording from the end of the previous
recording leaving no blank space, there may be
situations where a clean transition is not possible.
To Next Page
Loading...
