JVC GZ-MG730 - Attaching the Core Filter to the USB Cable and DC Cord; Attaching the Shoulder Strap; Preparing the Remote Control

11
ENGLISH
Attaching the Shoulder Strap
Peel off the pad and thread
the end of the strap through
the eyelet.
Thread the strap through the
buckle, adjust its length, and use
the strap guide to fix it in place.
Position the buckle near the
eyelet and reattach the pad.
Preparing the Remote Control
A battery is included inside the remote control at the time of purchase.
Remove the insulation sheet before use.
Effective Beam Distance To Reinsert the Battery
Pull out the battery holder by pressing the
lock tab.
NOTE
The transmitted beam may not be effective
or may cause incorrect operation when the
remote sensor is directly exposed to sunlight
or powerful lighting.
Eyelet
Strap Guide
Buckle
Effective distance:
5 m
Remote Sensor
Lock Tab
Lithium Battery
(CR2025)
Attaching the Core Filter to the USB Cable and DC Cord
Attach the core filter (Large) to the USB cable. Also, attach the core filter (Small) to the DC
Cord. The core filter reduces interference. Connect the end of the cable with the core filter to the
camera.
Release the stopper.
3 cm
Wind once.