JVC GZ-MG730 - Charging the Battery Pack; Necessary Settings before Use

16
Be sure to configure the following three
settings before use.
Charging the Battery Pack
1
Close the LCD monitor to turn off the
camera.
2
Attach the battery pack.battery pack.
Slide the battery pack down until it locks
in place.
Bottom of the Camera
3
Connect the AC adapter.
•
Connect the power cord to the AC adapter,
and plug the power cord into an AC outlet.
•
You can also connect the AC adapter using
the Everio dock connector. (p. 10)
•
The power/charge lamp blinks to indicate
charging has started.
•
When the lamp goes out, charging is
finished. Unplug the AC adapter from the
AC outlet and disconnect the AC adapter
from the camera.
L
To detach the battery pack
Slide and hold BATT. (step 2), then
remove the battery pack.
L
To check the remaining battery power
See page 18.
NOTES
•
You can also use the camera with just the
AC adapter.
•
Please do not pull or bend the AC adapter
plug and cable. This may damage the AC
adapter.
Necessary Settings before Use
DC Jack
AC Adapter
To AC Outlet
(110V to 240V)