JVC HX-Z10C User Manual

9
Common Operations
Turning On or Off the Power
To turn on the unit, press (or
STANDBY/ON on the remote
control) so that the STANDBY lamp
goes off.
To turn off the unit (standby), press
(or STANDBY/ON on the
remote control) again so that the
STANDBY lamp lights up.
• A little power is always consumed even while the unit is on
standby.
To switch off the power supply completely, unplug the AC
power cord from the AC outlet.
When you unplug the AC power cord or if a power
failure occurs
The clock is reset to “0:00” immediately, while the tuner preset
stations (see page 13) will be erased in a few days.
Saving the Power Consumption while on Standby
(Ecology Mode)
You can save the power consumption while the unit is turned
off (on standby).
• You can set Ecology Mode whether the unit is on or off.
On the unit ONLY:
To activate the Ecology Mode, press
ECO.
“ECO” appears on the display for 2 seconds (and
demonstration is canceled temporarily if you have pressed the
button while the unit is off).
• Each time you press the button, “ECO” and “NORMAL”
appear alternately on the display.
To deactivate the Ecology Mode, press ECO again.
“NORMAL” appears (and demonstration starts if the unit is
turned off).
When you turn off the unit with Ecology Mode activated
“ECO” flashes on the display, and the clock time will not be shown
while the unit is turned off.
ECO
STANDBY
ECO
STANDBY
ECO
STANDBY
Setting the Clock
Before operating the unit any further, first set the clock built
in this unit. “0:00” will flash on the display until you set the
clock.
• You can set the clock whether the unit is on or off.
• If Ecology Mode is activated, you cannot set the clock
while the unit is off.
On the unit ONLY:
1 Press CLOCK/TIMER.
The hour digits start flashing on the display.
2 Turn ¢ / 4
to adjust the
hour, then press
SET/DISPLAY.
The minute digits start
flashing on the display.
To correct the hour after pressing
SET/DISPLAY, press CANCEL/DEMO.
The hour digits start flashing again.
3 Turn ¢ / 4
to adjust the
minutes, then
press
SET/DISPLAY.
To check the clock time while playing a source
Press and hold SET/DISPLAY.
• Each time you press and hold the button, the source indication
and the clock time alternate on the display.
To adjust the clock again
If you have set the clock before, press CLOCK/TIMER
repeatedly until the clock setting mode is selected.
• Each time you press the button, the clock/timer setting
modes change as follows:
SET
/
DISPLAY
P
R
E
S
E
T
T
U
N
I
N
G
CLOCK
/TIMER
SET
/
DISPLAY
P
R
E
S
E
T
T
U
N
I
N
G
CANCEL
/ DEMO
DAILY
Canceled
TIMER
(Daily Timer setting)
TIMER
(Recording Timer setting)
REC
Clock
setting
(The hour digits start flashing.)
09-13.CA-HXZ10[A&B]3 03.2.12, 2:17 PM9

JVC HX-Z10C Specifications

General

Brand	JVC
Model	HX-Z10C
Category	Stereo System
Language	English