JVC KD-BT11 - General Settings - PSM

ENGLISH
24
3 Adjust the PSM item selected.
4 Repeat steps 2 and 3 to adjust other PSM
items if necessary.
5 Finish the procedure.
You can change PSM (Preferred Setting Mode) items
listed in the table below and on pages 25 and 26.
1 Enter the PSM settings.
2 Select a PSM item.
General settings — PSM
Indications Item
( : Initial)
Setting, [reference page]
DEMO
Display
demonstration
• DEMO ON
• DEMO OFF
: The display demonstration will be activated automatically if no
operation is done for about 20 seconds, [4].
: Cancels.
CLOCK DISP *
1
Clock display
• CLOCK ON
• CLOCK OFF
: The clock time is always shown on the display when the power is
turned off.
: Cancels; pressing DISP will show the clock time for about 5 seconds
when the power is turned off, [4].
CLOCK HOUR
Hour adjustment
0 – 23
(1 – 12)
[Initial: 0 (0:00)], [4].
CLOCK MIN
Minute adjustment
00 – 59 [Initial: 00 (0:00)], [4].
Preset value setting for each sound mode
Sound
mode
Preset value
BASS (bass) MID (mid-range) TRE (treble) LOUD
(loudness)
Freq. Level Q Freq. Level Q Freq. Level Q
USER 60 Hz 00 Q1.25 1.0 kHz 00 Q1.25 10.0 kHz 00
Fix OFF
ROCK 100 Hz +03 Q1.0 1.0 kHz 00 Q1.25 10.0 kHz +02
CLASSIC 80 Hz +01 Q1.25 1.0 kHz 00 Q1.25 10.0 kHz +03
POPS 100 Hz +02 Q1.25 1.0 kHz +01 Q1.25 10.0 kHz +02
HIP HOP 60 Hz +04 Q1.0 1.0 kHz –02 Q1.0 10.0 kHz +01
JAZZ 80 Hz +03 Q1.25 1.0 kHz 00 Q1.25 10.0 kHz +03
Freq.: Frequency Q: Quality slope
EN22-29_KD-BT11_003A_5.indd 24EN22-29_KD-BT11_003A_5.indd 24 12/7/07 3:36:36 PM12/7/07 3:36:36 PM