JVC KD-BT11 - Page 147

ENGLISH
21SETTINGS
Indications Item
( : Initial)
Setting, [reference page]
PTY-STANDBY *
2
PTY standby
OFF, PTY codes Activates PTY Standby Reception with one of the PTY codes, [8].
TA VOLUME *
2
Traffic
announcement
volume
VOLUME 00 –
VOLUME 50 (or
VOLUME 00 –
VOLUME 30)*
3
Initial: VOLUME 15
P-SEARCH *
2
Programme search
• ON
• OFF
: Activates Programme Search, [9].
: Cancels.
DIMMER
Dimmer
• AUTO
• ON
• OFF
: Dims the display and button illumination when you turn on the
headlights.
: Activates dimmer.
: Cancels.
SCROLL *
4
Scroll
• ONCE
• AUTO
• OFF
: Scrolls the displayed information once.
: Repeats scrolling (at 5-second intervals).
: Cancels.
• Pressing DISP for more than one second can scroll the display
regardless of the setting.
L/O MODE
Line output mode
• REAR
• SUB.W
: Select if the REAR LINE OUT terminals are used for connecting the
rear speakers (through an external amplifier).
: Select if the REAR LINE OUT terminals are used for connecting a
subwoofer (through an external amplifier).
SUB.W FREQ *
5
Subwoofer cutoff
frequency
• LOW
• MID
• HIGH
: Frequencies lower than 90 Hz are sent to the subwoofer.
: Frequencies lower than 135 Hz are sent to the subwoofer.
: Frequencies lower than 180 Hz are sent to the subwoofer.
SUB.W PHASE *
6
Subwoofer phase
• 180 DEG
• 0 DEG
: Select either “0 DEG” or “180 DEG” which reproduces a better sound.
TAG DISPLAY
Tag display
• TAG ON
• TAG OFF
: Shows the Tag information while playing MP3/WMA tracks.
: Cancels.
AMP GAIN
Amplifier gain
control
• LOW POWER
• HIGH POWER
: VOLUME 00 – VOLUME 30 (Select this if the maximum power of the
speaker is less than 50 W to avoid damaging the speaker.)
: VOLUME 00 – VOLUME 50
IF BAND
Intermediate
frequency band
• AUTO
• WIDE
: Increases the tuner selectivity to reduce interference noises between
adjacent stations. (Stereo effect may be lost.)
: Subject to interference noises from adjacent stations, but sound
quality will not be degraded and the stereo effect will remain.
*
1
If the power supply is not interrupted by turning off the ignition key of your car, it is recommended that you select
“CLOCK OFF” to save the car’s battery.
*
2
Only for RDS FM stations.
*
3
Depends on the amplifier gain control.
*
4
Some characters or symbols will not be shown correctly (or will be blanked) on the display.
*
5
Displayed only when “L/O MODE” is set to “SUB.W.”
EN18-23_KD-BT11[EE]_8.indd 21EN18-23_KD-BT11[EE]_8.indd 21 12/18/07 11:57:12 AM12/18/07 11:57:12 AM