ENGLISH
11OPERATIONS
Connecting a Bluetooth device for
the first time
Pairing and PIN code
When you connect a Bluetooth device to the unit
for the first time, make pairing between the unit
and the device. Pairing allows Bluetooth devices to
communicate with each other.
To make pairing, you may need to enter the PIN
(Personal Identification Number) code of your Bluetooth
device you want to connect.
• Once the connection is established, it is registered in
the unit even if you reset the unit. Up to five devices
can be registered in total.
• Only one device for Bluetooth phone and one for
Bluetooth audio can be connected at a time.
• To use the Bluetooth function, you need to turn on
Bluetooth function of the device.
Preparation: Operate the device to turn on its
Bluetooth function.
1 While listening to a source...
2 Select “DEVICE.”
3 Select “NEW PAIRING.”
Continued on the next page
4 Enter a PIN (Personal Identification Number)
code to the unit.
• You can enter any number you like (1-digit to
16-digit number). [Initial: 0000]
* Some devices have their own PIN code. Enter the
specified PIN code to the unit.
1 Move to the next (or previous) number
position.
2 Select a number.
3 Repeat steps 1 and 2 until you finish
entering a PIN code.
4 Confirm the entry.
5 Operate the target Bluetooth device, (while
“WAIT PAIR” is flashing on the display).
On the device to be connected, enter the same PIN
code you have just entered for this unit.
“PAIRING” flashes, then “PAIRING OK” appears on
the display when the connection is established.
Now you can use the device through the unit.
The device remains registered even after you
disconnect the device. Use “CNNCT PHONE” or
“CNNCT AUDIO” (or activate “AUTO CNNCT”) to
connect the same device from next time on. (See
pages 12 and 27.)
EN08-15_KD-BT11_003A_3.indd 11EN08-15_KD-BT11_003A_3.indd 11 11/30/07 3:11:36 PM11/30/07 3:11:36 PM
To Next Page
Loading...
Need help?
General
Weight and Dimensions
