JVC KD-G801 User Manual

50
ENGLISH
3 Tune in to an ensemble you want.
4 Select a service of the ensemble you
want to listen to.
5 Press and hold the number button
(in this example, 1) for more than
2 seconds to store the selected
service into the preset number you
want.
6 Repeat the above procedure to store
other DAB services into other preset
numbers.
Notes:
• You can only preset primary DAB services. If you
store a secondary service, its primary service will
be stored instead.
• A previously preset DAB service is erased when a
new DAB service is stored in the same preset
number.
• Preset DAB services are erased when the power
supply to the memory circuit is interrupted (for
example, during battery replacement). If this
occurs, preset the DAB services again.
To select the next service
To select the previous service
Tuning in to a preset DAB
service
You can easily tune in to a preset DAB service.
Remember that you must store services first. If
you have not stored them yet, see “Storing DAB
services in memory” on pages 49 and 50.
Before you start....
Press FM/AM DAB briefly if CD, CD changer, or
external component is the current source.
1 Select the DAB tuner.
Each time you press and
hold the button, the DAB
tuner and the FM/AM tuner
are alternately selected.
2 Select the DAB band (DAB1, DAB2,
or DAB3) you want.
Each time you press the
button, the DAB band
changes as follows:
3 Select the number (1 – 6) for the
preset DAB service (primary) you
want.
Note:
If the selected primary service has some secondary
services, pressing the same number button repeatedly
will tune in to the secondary services.
FM/AMDAB
DAB 1
(d1)
DAB 2
(d2)
DAB 3
(d3)
Selected preset number
EN48-51_G801_G701[E_EX]f.p65 1/6/04, 12:10 PM50

JVC KD-G801 Specifications