JVC KD-LH1100 - Tuning in to a Preset Station

13
ENGLISH
Selecting a preset station using the
preset station list
If you forget what stations are stored in what
preset numbers, you can check the preset station
list, then select your desired station.
1 Select the band (FM1 – 3, AM).
Each time you press the
button, the band changes as
follows:
2 Press and hold 5 (up) or ∞ (down)
until the preset station list for the
current band (FM1, FM2, FM3, or AM)
appears on the display.
Notes:
• You can show the other FM band preset station lists
(FM1, FM2, or FM3) by pressing 5 (up) or ∞
(down).
• If a name has been assigned to a station (see page
31), it will be shown instead of the station
frequency.
3 Select the number (1 – 6) for the
preset station you want.
FM1 FM2 FM3 AM
Tuning in to a preset station
You can easily tune in to a preset station.
Remember that you must store stations first. If
you have not stored them yet, see “Storing
stations in memory” on pages 11 and 12.
Selecting a preset station directly
1 Select the band (FM1 – 3, AM).
Each time you press the
button, the band changes as
follows:
2 Select the number (1 – 6) for the
preset station you want.
Note:
You can also use the 5 (up) or ∞ (down) button on
the unit to select the next or previous preset stations.
Each time you press the 5 (up) or ∞ (down) button,
the next or previous preset station is tuned in.
FM1 FM2 FM3 AM
EN10-14KD-LH1150_1100[J]f.p65 1/25/03, 11:17 AM13