JVC KD-LH810 - General Settings (PSM); Basic PSM Procedures

28
ENGLISH
Basic procedure
You can change PSM (Preferred Setting Mode)
items listed in the table that follows.
1 Enter the PSM menu (see page 5).
2 Select a PSM item.
Ex.: When “Dimmer” is selected
General settings — PSM
3 Adjust the setting.
4 Repeat steps 2 and 3 to adjust the
other PSM items if necessary.
5 Finish the procedure.
Indications Selectable settings, [reference page]
Demo/Link
Display
demonstration
Demo: [Initial]; Display demonstration (animation) and
playback source indication appears alternately.
Image Link: To show a still image while playing back an
MP3/WMA track, [13, 46].
Off: Cancels.
• These graphics appear if no operation is done for about 20 seconds.
Pict
Pictures
You can activate the graphic screen using either movie or picture, [27].
Picture: [Initial]; One of your edited still images stored in
“Picture” is activated.
Movie: Your edited animation stored in “Movie” is activated.
Slideshow: Your edited still images stored in “Slide” are activated
and shown in sequence.
KeyIn CFM
Key-in confirmation
On: [Initial]; An animation screen appears when you turn on or off the
power and select an i-EQ.
Off: Cancels.
Opening*
1
Opening screen
Default: [Initial]; Factory-preset animation is used, [24].
User: Your own user animation is used.
Ending*
1
Ending screen
EN26-31_KD-AR860[J]f.indd 28EN26-31_KD-AR860[J]f.indd 28 12/17/04 5:42:25 PM12/17/04 5:42:25 PM