ENGLISH
20
Listening to the iPod/iPhone
You can connect the iPod/iPhone using the following cable or adapter:
Cable/adapter To operate
USB 2.0 cable (supplied with the iPod/iPhone) to the
USB input jack on the control panel
See “When connected with the USB cable” below.
Interface adapter for iPod, KS-PD100 (not supplied) to
the CD changer jack on the rear of the unit
See “When connected with the interface adapter” on
page 22.
• Disconnecting the iPod/iPhone will stop playback. Press SRC to listen to another playback source.
• For details, refer also to the manual supplied with your iPod/iPhone.
Caution:
• Avoid using the iPod/iPhone if it might hinder your safety while driving.
• Make sure all important data has been backed up to avoid losing the data.
When connected with the USB cable
There are 2 control terminals in “USB-IPOD” source.
• “HEAD MODE”: control by this unit.
• “IPOD MODE”: control by the connected iPod/iPhone.
Preparation: Select the controlling terminal, “HEAD MODE” or “IPOD MODE” for iPod playback:
• Press and hold BACK button.
• Make the selection from “IPOD SWITCH” setting, see page 30.
The operations explained below are under “HEAD MODE.”
1
Select “USB-IPOD.”
Playback starts automatically.
2
Select a song.
EN14-25_KD-R601_003A_4.indd 20EN14-25_KD-R601_003A_4.indd 20 19/12/08 11:33:16 AM19/12/08 11:33:16 AM
To Next Page
Loading...
