ENGLISH
29
SETTINGS
Category
Menu items Selectable settings, [reference page]
MENU
COLOR
MENU COLOR
Menu color
• ON
• OFF
: Changes the display and button (except EQ/ /0)
illumination during menu, list search and playback mode
operations.
: Cancels.
RING COLOR
RING COLOR *
9
Ring color
• ON
• OFF
: When a call comes in, the display will flash in blue.
• The display will change to the original color when you
answer the call or the incoming call stops.
When the unit receive a text message, the display only
illuminate in blue.
: Cancels.
AUDIO
FADER *
10,
*
11
Fader
R06 – F06 : Adjust the front and rear speaker output balance.
(Initial: 00)
BALANCE *
11
Balance
L06 – R06 : Adjust the left and right speaker output balance.
(Initial: 00)
LOUD
Loudness
• LOUD ON
• LOUD OFF
: Boost low and high frequencies to produce a
well-balanced sound at a low volume level.
: Cancels.
VOL ADJUST
Volume adjust
VOL ADJ –05 —
VOL ADJ +05
(Initial: VOL ADJ
00)
: Preset the volume adjustment level of each source
(except FM), compared to the FM volume level. The
volume level will automatically increase or decrease
when you change the source.
• Before making an adjustment, select the source you
want to adjust.
• “VOL ADJ FIX” appears on the display if “FM” is selected
as the source.
L/O MODE
Line output mode
• SUB.W
• REAR
: Select if the REAR LINE OUT terminals are used for
connecting a subwoofer (through an external amplifier).
: Select if the REAR LINE OUT terminals are used for
connecting the speakers (through an external amplifier).
SUB.W FREQ *
12
Subwoofer cutoff
frequency
• LOW
• MID
• HIGH
: Frequencies lower than 72 Hz are sent to the subwoofer.
: Frequencies lower than 111 Hz are sent to the subwoofer.
: Frequencies lower than 157 Hz are sent to the subwoofer.
SUB.W LEVEL *
12
Subwoofer level
SUB.W 00
— SUB.W 08
: Adjust the subwoofer output level.
(Initial: SUB.W 04)
*
9
Displayed only when Bluetooth adapter, KS-BTA200 is connected.
*
10
If you are using a two-speaker system, set the fader level to “00.”
*
11
This adjustment will not affect the subwoofer output.
*
12
Displayed only when “L/O MODE” is set to “SUB.W.”
Continued on the next page
EN26-35_KD-R601_003A_4.indd 29EN26-35_KD-R601_003A_4.indd 29 19/12/08 11:28:24 AM19/12/08 11:28:24 AM