11
ENGLISH
200
CD OPERATIONS
Playing a CD
1
Open the control panel.
Note:
When an external component is connected to the MP3
INPUT jack on the control panel, be careful of
handling a CD.
2
Insert a disc into the loading slot.
The unit turns on,
draws the disc and
starts playback
automatically.
3
Close the control panel by hand.
The CD–in indicator lights up.
Total track number
of the inserted disc
Total playing time of
the inserted disc
Elapsed playing time
Current track
Changes to the clock time
when “CLOCK” is set to
“ON” (see page 19).
Notes:
• When a disc is in the loading slot, selecting “CD”
as the source starts CD play.
• When a disc is inserted upside down, the disc
automatically ejects (if the control panel is open).
If the control panel is closed, “PLEASE” and
“EJECT” appear alternately.
• When you open the control panel by pressing 0, the
CD automatically ejects.
To stop play and eject the disc
Press 0.
CD play stops, the control panel opens, then the
CD automatically ejects from the loading slot.
If you change the source, the CD play also stops
(without ejecting the CD this time).
Notes:
• If the ejected disc is not removed within 15 seconds,
the disc is automatically inserted again into the
loading slot to protect it from dust. (CD play will
not start this time.)
• You can eject the CD even when the unit is turned off.
EN11-13.KD-SX8250_SX780[J]f.pm5 22/12/01, 10:38 AM11
To Next Page
Loading...
Need help?
General
