JVC KD-X262 - Getting Started; Cancel Demonstration Mode; Set Clock and Date; Configure Basic Settings

ENGLISH
5
Data Size: B6L (182 mm x 128 mm)
Book Size: B6L (182 mm x 128 mm)
GETTING STARTED
For key layout on the faceplate, see page 3 or page 4.
Cancel the demonstration
When you turn on the power for the first time (or after you reset the unit),
the display shows:
KD-X262/KD-X162:
“CANCEL DEMO”
“PRESS” “VOLUME KNOB”
1 Press the volume knob.
[YES] is selected for the initial setup.
2 Press the volume knob again.
“DEMO OFF” appears.
KD-X161:
“CANCEL DEMO” “PRESS ENTER”
1 Press * ENTER.
[YES] is selected for the initial setup.
2 Press * ENTER again.
“DEMO OFF” appears.
Set the clock and date
1
Press and hold .
2 Perform ‘Select an item (page3 or 4)’ operation to select
[CLOCK] .
3 Perform ‘Select an item (page3 or 4)’ operation to adjust the
clock.
[CLOCKADJUST] set the hour and minute [CLOCKFORMAT]
[12H] or [24H]
4 Perform ‘Select an item (page3 or 4)’ operation to set the date.
[DATESET] set the day, month and year
5 Press to exit.
1
2
To return to the previous setting item, press .
Set the basic settings
1
Press and hold .
2 Perform ‘Select an item (page3 or 4)’ operation to select an
item (see the following table).
3 Repeat step 2 until the desired item is selected or activated.
4 Press to exit.
To return to the previous setting item, press
.
Default: [XX]
[SYSTEM]
[KEY BEEP]
[ON]: Activates the keypress tone. ; [OFF]: Deactivates.
[SOURCE SELECT]
[AM SRC]*
[ON]: Enables AM in source selection. ; [OFF]: Disables. (Page 6)
[BUILT-IN AUX]*
[ON]: Enables AUX in source selection. ; [OFF]: Disables. (Page 8)
[F/W UPDATE]
[UPDATE SYSTEM]
[F/W UP xxxx]
[YES]: Starts upgrading the firmware. ; [NO]: Cancels (upgrading is not
activated).
For details on how to update the firmware, visit
<http://www.jvc.net/cs/car/>.
* Not displayed when the corresponding source is selected.
3
JS_JVC_KD_X262_E_EN_3.indd 5JS_JVC_KD_X262_E_EN_3.indd 5 8/14/2018 11:35:05 AM8/14/2018 11:35:05 AM