JVC KW-R950BTS User Manual

ENGLISH
5
Data Size: B6L (182 mm x 128 mm)
Book Size: B6L (182 mm x 128 mm)
Remote control (RM-RK52) (for KW-R950BTS)
This unit can be remotely controlled with an optionally purchased remote
control.
How to replace the battery
To On the remote control
Adjust the volume Press VOL + or VOL – .
• Press and hold VOL + to continuously increase
the volume to 15.
Press d to mute the sound or pause playback.
• Press again to cancel. The volume level returns to
the previous level before muting or pause.
Select a source Press SOURCE repeatedly.
Basics Getting Started
Acknowledge the crossover type and cancel the
demonstration
When you turn on the power for the first time (or [FACTORY RESET] is set to
[YES] , see page6), the display shows: “2-WAY X’OVER” or “3-WAY X’OVER”
“PRESS” “VOLUME KNOB” “TO CONFIRM”.
1 Press the volume knob to acknowledge the current crossover type.
Then, the display shows: “CANCEL DEMO” “PRESS” “VOLUME KNOB”
• To change the crossover type, see page29.
2 Press the volume knob.
[YES] is selected for the initial setup.
3 Press the volume knob again.
“DEMO OFF” appears.
Set the clock and date
1
Press and hold MENU.
2 Turn the volume knob to select [CLOCK] , then press the knob.
1
2
Remote sensor (Do not expose to bright sunlight.)
Pull out the insulation sheet
when using for the first time.
KW_R950BTS_K_B5A-3883-00_EN_1st Draft.indd 5KW_R950BTS_K_B5A-3883-00_EN_1st Draft.indd 5 9/7/2021 11:39:34 PM9/7/2021 11:39:34 PM

JVC KW-R950BTS Specifications

General

Brand	JVC
Model	KW-R950BTS
Category	Car Receiver
Language	English