SETTINGS
Sound adjustment
R Using the sound equalization
• The adjustment is memorized for each source until
you adjust the sound again. If the source is a disc,
the adjustment is stored for each of the following
categories.
– DVD-Video/DVD-VR/VCD
–CD
– DivX/MPEG1/MPEG2/MP3/WMA/AAC
• You cannot adjust the sound when the AV source
is turned off.
Selecting a preset sound mode
1 Display the <Equalizer> screen.
On the Home screen:
• You can also display the <Equalizer> screen
by pressing [
] on the pop-up short-cut
menu. (Page9)
2 Select a sound mode.
• You can change the page to display more
items by pressing [J]/[K].
Storing your own adjustments—Customizing
preset sound mode
1 Select a sound mode. (See the left column.)
2 Adjust the level of each band (1), then
select the subwoofer level (2).
The adjustments are stored and <User> is
activated.
• To finish the procedure, press [
].
Storing your own adjustments—Adjusting the
sound precisely
1 Select a sound mode. (See the left column.)
2 Display the adjustment screen.
3 Select a band.
4 Adjust the sound.
[Reset] Changes the level of each band
to 0.
<FREQ> Selects the frequency.
<Q> Adjusts the width of the
frequency.*
1
<Bass> Activates/deactivates bass.*
2
<SW Level> Adjusts the subwoofer level.
The adjustments are overwritten if the <User>
setting has been created (see the left column),
and <User> is activated.
• To finish the procedure, press [
].
• The adjustments are memorized until you adjust
the sound again.
• To make adjustments for other bands, repeat
steps 3 and 4.
*
1
Fixed for “High” band.
*
2
Only for “Low” band.
To Next Page
Loading...
