38
English
Specifications
Amplifier
Output Power
At Stereo operation
Front channels: 100 W*
1
per channel, min. RMS, driven into
8 Ω, at 1 kHz with no more than 0.8% total
harmonic distortion (IEC268-3/DIN).
At Surround operation
Front channels: 100 W per channel, min. RMS, driven into
8 Ω, at 1 kHz with no more than 0.8% total
harmonic distortion.
Center channel: 100 W, min. RMS, driven into 8 Ω, at 1 kHz
with no more than 0.8% total harmonic
distortion.
Surround channels: 100 W per channel, min. RMS, driven into
8 Ω, at 1 kHz with no more than 0.8% total
harmonic distortion.
(*
1
Measured on AC 110 V, 127 V, 220 V, and 240 V)
Audio
Audio Input Sensitivity/Impedance (1 kHz)
CD, TAPE/CDR, VCR, TV SOUND, DVD: 220 mV/47 kΩ
Audio Input (DIGITAL IN)*
2
Coaxial DIGITAL 1 (DVD): 0.5 V(p-p)/75 Ω
Optical RX-6042S
DIGITAL 2 (CD), DIGITAL 3 (TV):
–21 dBm to –15 dBm (660 nm ±30 nm)
RX-5042S
DIGITAL 2 (CD):
–21 dBm to –15 dBm (660 nm ±30 nm)
*
2
Corresponding to Linear PCM, Dolby Digital, and DTS
Digital Surround (with sampling frequency—32 kHz,
44.1 kHz, 48 kHz)
Recording Output Level
TAPE/CDR, VCR: 220 mV
Signal-to-Noise Ratio (’66 IHF/DIN)
CD, TAPE/CDR, VCR, TV SOUND, DVD: 87 dB/62 dB
Frequency Response (8 Ω)
CD, TAPE/CDR, VCR, TV SOUND, DVD:
20 Hz to 50 kHz (+1 dB, –3 dB)
Bass Boost—Only for RX-6042S: +3 dB ±1 dB at 100 Hz
Equalization (5 bands)
63 Hz, 250 Hz, 1 kHz, 4 kHz, 16 kHz: ±8 dB (in 2 dB steps)
Main differences between the models
Models Output/Input terminals Sources Functions
COMPONENT
S-VIDEO Analog discrete DVD MULTI Bass Boost Center Tone AV Compulink
(IN/OUT) (IN/OUT) (DVD MULTI)
RX-6042S ‡‡ ‡ ‡‡‡
AV COMPULINK-III
RX-5042S ×× × ×××AV COMPULINK
• The remote control supplied with RX-6042S can operate other manufacture’s video equipment, but the one with RX-5042S cannot.
‡: Equipped ×: Not equipped
Designs and specifications are subject to change without notice.
Video
Video Input Sensitivity/Impedance
Composite video
DVD, VCR: 1 V(p-p)/75 Ω
S-video—Only for RX-6042S
DVD, VCR
(Y: luminance): 1 V(p-p)/75 Ω
(C: chrominance, burst): 0.286 V(p-p)/75 Ω
Component—Only for RX-6042S
DVD, VCR
(Y: luminance): 1 V(p-p)/75 Ω
(P
B, PR): 0.7 V(p-p)/75 Ω
Video Output Level
Composite video
VCR, MONITOR OUT: 1 V(p-p)/75 Ω
S-video—Only for RX-6042S
VCR, MONITOR OUT
(Y: luminance): 1 V(p-p)/75 Ω
(C: chrominance, burst): 0.286 V(p-p)/75 Ω
Component—Only for RX-6042S
MONITOR OUT
(Y: luminance): 1 V(p-p)/75 Ω
(P
B, PR): 0.7 V(p-p)/75 Ω
Synchronization: Negative
Signal-to-Noise Ratio: 45 dB
FM tuner (IHF)
Tuning Range: 87.50 MHz to 108.00 MHz
Usable Sensitivity Monaural: 12.8 dBf (1.2 µV/75 Ω)
50 dB Quieting Sensitivity Monaural: 16.0 dBf (1.7 µV/75 Ω)
Stereo: 37.5 dBf (20.5 µV/75 Ω)
Stereo Separation at OUT (REC): 35 dB at 1 kHz
AM tuner
Tuning Range: 531 kHz to 1 602 kHz (at 9 kHz intervals)
530 kHz to 1 600 kHz (at 10 kHz intervals)
General
Power Requirements: AC 110 V/127 V/220 V/230 V – 240 V ,
adjustable with the voltage selector,
50 Hz/60 Hz
Power Consumption
For RX-6042S: 200 W (at operation)
2 W (in standby mode)
For RX-5042S: 210 W (at operation)
4.5 W (in standby mode)
Dimensions (W x H x D)
For RX-6042S: 435 mm x 146.5 mm x 409.5 mm
For RX-5042S: 435 mm x 146.5 mm x 369.5 mm
Mass
For RX-6042S: 9.8 kg
For RX-5042S: 8.0 kg
31-38_5042&6042[US]f.p65 04.2.4, 5:45 PM38
To Next Page
Loading...
