(No.PA063<Rev.001>)1-7
Page-3
Page-4
Page-5
Page-6
Motor Blower Fan Real FAN6 Current speed Monitor
N/A -
N/A -
Manual Fan speed
Change prohibited.
Error Check Detect
Item Contents
Calibration RGB
<Press L or R>
-
Red Offset
Calibration Value
Green Offset
Blue Offset
Red Gain
Green Gain
Blue Gain
Source Detail Information
Source information
Input Source
Resolution
Color System
Item Contents
Lamp Status
Error Count
Ballast Error Status
Color Wheel Start Fail
Phospher Wheel Start Fail
UART Faill
Ignition Fail Error Count
(Light source NG)
Lamp Fail
Temperature 1 Error
Error Count
Temperature 2 Error
Fan#1 Speed Error
Error Count
(Fan speed error)
Fan#2 Speed Error
Fan#3 Speed Error
Fan#4 Speed Error
Fan#5 Speed Error
Fan#6 Speed Error
Fan#7 Speed Error -
Fan#8 Speed Error -
FanIC 1 Error Error Count
(Fan control IC error)
FanIC 2 Error
Scaler Reset Error Error Count
Abonormal Power Down System abnormal power
down
Error Count Reset
<Press L or R>
Notice: Once pressing reset,
projector will erase all error
count record on page-4.
Item Contents
Item Contents
Burn In ON Minutes
Change prohibited.
(Only for Factory test)
Burn In Off Minutes
Burn In Cycle Time
Normal Burn In Hour
Burn In Active
Life Time Burn In Active
SmartEco LifeTime
First Burn In Error Minutes
Reset First Burn In Error Minutes
Recall Number 0
Recall Number 1
Recall Number 2
Recall Number 3
Decode
<Press L or R>
Item Contents
Picture mode Picture mode
Color Temperature Color Temperature
R Gain
Picture Mode Value
G Gain
B Gain
R Offset
G Offset
B Offset
Color
Hue
Saturation
Gain
W R gain
W G gain
W B gain
------LED PWM-------
R
G
B
Y
To Next Page
Loading...
Need help?
General
Weight and Dimensions
