JVC MX-G50 Service Manual

MX-G50/MX-G56
1-11
Disconnect the card wire from the connector UCW3,
UCW4,UCW5 and UCW6 on the FL & system control
board.
Remove the five screws U attaching the FL & system
board.
Disconnect the card wire from the connector UCW2
on the FL & system control board.
1.
2.
3.
Removing the FL display & system
control board
(See Fig.22 and 23)
Disconnect the card wire from connector UCW1 of
the power / CD switch board.
Remove the five screws T attaching the power / CD
switch board and release the tab e outward.
1.
2.
Prior to performing the following procedure, remove
the metal cover, the CD changer unit and the front
panel assembly.
Removing the power / CD switch board
(See Fig.22)
Prior to performing the following procedure, remove
the FL display & system control board.
Pull out the volume knob, subwoofer knob and sound
mode nob from front side.
Remove the ten screws V attaching the front board
and release the two tabs f out ward.
1.
2.
Removing the front board (See Fig.24)
<Front panel assembly>
Prior to performing the following procedure remove
the FLdisplay & system control board.
You can pull out the headphone board.
1.
Removing the headphone board
(See Fig.24)
Disconnect the card wire x from the mechanism
board on the cassette mechanism assembly.
Remove the six screws W attaching the cassette
mechanism assembly.
1.
2.
Removing the cassette mechanism
assembly (See Fig.24)
Fig.22
Fig.23
Fig.24
Headphone
board
Tab e
Cassette mechanism assembly
T
Power / CD switch board
V
V
U
U
FLdiplay & system
control board
W
Front board
Card wire x
Sound mode knob
Volume knob
Subwoofer knob
f
V
UCW2
UCW3
UCW4
UCW5
UCW6

JVC MX-G50 Specifications

General

Brand	JVC
Model	MX-G50
Category	Speaker System
Language	English