Basic Operations
F_ Remotecontrol
MASTER VOLUME
DIMMER control
PHONES
jack
SPEAKERS SOURCE NAME Audio source
ON/OFF (TAPE/CDR) selection buttons
Audio source
selection -_-
buttons
DIMMER --
-- MUTING
VOLUME +/-
When you have connected a CD recorder to the TAPE/CDR
jacks on the rear panel, change the source name to CDR so
that "CDR" appears on the display when selected as the
source.
RX-6030VBK/RX-6032VSL
I _ I ..... I ' I I]
RX-5030VBK/RX-5032VSLI I I I]
Press TAPEJCDR (SOURCE NAME) on the
front panel to select "TAPE" as the source,
2 Press again and hold SOURCE NAME
(TAPE/CDR) on the front panel until
"ASSIGN CDR" appears on the display.
To change the source name from "CDR" to "TAPE," repeat
the same procedure above.
Note:
Without changing the source name, you can still use the connected
components; however, you may experience one of the following
inconveniences:
• A different source name will appear on the display when you select
the target component,
• You cannot use the digital input (see page 16) for the CD recorde_
• You cannot use the COMPU LINK remote control system (see page
29) to operate the target component.
You can watch the picture from a video component while
listening to sound from another component.
Press one of the audio source selection buttons while
watching the picture from a video component such as the
VCR or DVD player.
• Once you have selected a video source, pictures of the
selected source are sent to the TV until you select another
video source.
RX-6030VBIURX-6032VSL
I _ I ...... I., I _, II
On the trent panel
RX-5030VBK/RX-5032VSL
On the front panel
O
From the remote control
TAp_ICDR CD _V_i
0 0
AAO_
0 " '
From the remote control
1_2
To Next Page
Loading...
