Basic Operations
F_ Remotecontrol
MASTER VOLUME
DIMMER control
PHONES SPEAKERS SOURCE NAME Audio source
jack ON/OFF (TAPE/CDR) selection buttons
Audio source
selection ---_
buttons
DIMMER --
oo
oooo
@oo@
@@@
@@@
,,JVC
_ MUTING
VOLUME +/-
When you have connected a CD recorder to the TAPE/CDR
jacks on the rear panel, change the source name to CDR so
that "CDR" appears on the display when selected as the
source.
RX-6030VBKiRX-6032VSL
RX-5030VBKiRX-5032VSL
PressTAPE/CDR (SOURCE NAME) on the
front panel.
• Make sure"TAPE"appears on thedisplay.
2 Press again and hold SOURCE NAME
(TAPE/CDR) on the front panel until
"ASSIGN CDR" appears on the display.
To change the source name from "CDR" to "TAPE," repeat
the same procedure above (in step I, make sure "CDR"
appears on the display).
Note:
Without changing the source name, you can still use the connected
components; however, you may experience one of the following
inconveniences:
• A different source name will appear on the display when you select
the target component,
• You cannot use the digital input (see page 16) for the CD recorde_
• You cannot use the COMPU LINK remote control system (see page
29) to operate the target component.
You can watch the picture from a video component while
listening to sound from another component.
Press one of the audio source selection buttons while
watching the picture from a video component such as the
VCR or DVD player.
• Once you have selected a video source, pictures of the
selected source are sent to the TV until you select another
video source.
RX-6030VBI{/RX-6032VSL
On the trentpanel
RX-5030VBI{/RI-5032VSL
On the front panel
_4Ai OG
O ;;4
From the remote control
TAp_TCDR CD _V_i
0 0
AgA©_
FM/AM tSOX VO BOA
O "
From the remote control
]2
To Next Page
Loading...
Need help?
General
