After connecting and placing speakers, you need to make
basic settings for the following items according to your
listening conditions.
• Speaker information (see the next column and page 16)
• Digital input terminal sources (see page 16)
• RX-6030VBK and RX-6032VSL only:
Video input terminal type (see page 16)
• Operating buttons
4 Turn MULTI JOG dial to adjust the selected
item.
Select "SUBWOOFERYES" if a subwoofer is connected.
-= []SU]]H00FER YES
Ex.:When "SUBWOQFERYES" is selected.
Press EXIT.
Toadjust otheritems, repeatsteps 2 to 5.
Tofinish the setting, go to step 6.
6 Press EXIT again.
The receiver exitsfrom the basic setting mode.
Buttons To do
SETTING Enter the receiver into the basic setting
mode.
MULTI JOG • Select an item to adjust after pressing
SETTING.
• Adjust the selected item after pressing
SET.
SET Determine the item to adjust.
EXIT Exit from the basic setting mode or return
to the previous step.
• Operating procedure
Ex. Setting the subwoofer information
Before you start, remember...
There is a time limit in doing the following steps. If the setting
is canceled before you finish, start from step ! again.
Press SETTING.
The last selected item appears on the display.
2 Turn MULTI JOG dial to select an item you
want to adjust.
SUBWOOFER _ FRNT SPEAKERS _ CNTR SPEAKER
SURR SPEAKERS _ DISTANCE UNITZ PRNT DISTANCE
CNTR DISTANCE _ SURR DISTANCE Z CROSSOVER
LFEATTENUATE Z D COMPRESSION Z DIGITAL IN
VIDEO IN DVD* _ VIDEO IN VCR_ _ (back tothe beginning)
RX-603OVBKand RX-6032VSL only.
3 Press SET.
The currentsetting of the selected item appears on the
display.
-'= _'m
5U]]HOOFEP 1'40
Ex.:When "SUBWOOFER"is selected.
Setting the Speaker Information
"NO" for the subwoofer, "LARGE" for the front speakers, and
"SMALL' for the center and surround speakers are initial
settings.
To get best possible sound, change the subwoofer and
speaker settings to fit your listening conditions.
• Subwoofer information--SUBWOOFER
Register whether you have connected a subwoofer or not.
YES Select this when you have connected a subwoofer.
You can adjust the subwoofer output level
(see page 21 ).
NO Select this when you have not connected or have
disconnected a subwoofer.
• Speaker size--FRNT (Front) SPEAKERS, CNTR (Center)
SPEAKER, SURR (Surround) SPEAKERS
Register the sizes of all the connected speakers.
• When you change your speakers, register the information
about the speakers again.
LARGE Select this when the size of the cone speaker unit
built in your speaker is greater than 12 cm
(4 3/4inches).
SMALL Select this when the size of the cone speaker unit
built in your speaker is smaller than 12 cm
(4 3/4inches).
NONE Select this when you have not connected a
speaker. (Not selectable for the front speakers)
Notes:
• ffyou have selected "NO" for the subwoofer setting, you can only
select "LARGE" for the front speaker setting,
• ffyou have selected "SMALE' for the front speaker setting, you
cannot select "LARGE" for the center and surround speaker settings.
]5
To Next Page
Loading...
Need help?
General
