29
Operating JVC's Audio / Video Components
TEST
EFFECT
MENU
ENTER
CENTER
REAR L
SUBWOOFER
REAR R
1
4
7/P
10
2
5
8
0
3
6
9
10
100
RETURN
DVD player
You can always perform following operations:
STANDBY/ON DVD : Turn on or off a DVD player.
After pressing DVD or DVD MULTI, you can use following buttons
for DVD player operations:
33
33
3 : Start playback.
4 : Return to the beginning of the current
(or previous) track.
¢ : Skip to the beginning of the next track.
77
77
7 : Stop playback.
88
88
8 : Pause playback. To release it, press
33
33
3.
DVD menu operations
After pressing DVD or DVD MULTI, you can
use following buttons for DVD menu
operations:
MENU : Display or erase the menu screen.
55
55
5/
∞∞
∞∞
∞/
33
33
3/
22
22
2 : Select an item on the menu screen.
ENTER : Enter a selected item.
TV
You can always perform following operations:
STANDBY/ON TV : Turn on or off a TV.
TV/VIDEO : Change the input mode (TV tuner and video
input).
TV VOLUME +/– : Adjust the volume.
TV CH +/– : Change the channels.
After pressing TV SOUND, you can use following buttons for TV
operations:
1 – 9, 0, 100+ (+10) :Select a channel.
RETURN (10) :Function as the RETURN button.
Cassette deck
Before starting operations described below, make sure that you have
changed the source name correctly. See page 8.
After pressing TAPE/CDR, you can use following buttons for
cassette deck operations:
33
33
3 : Start playback.
FF : Fast wind the tape from left to right.
REW : Fast wind the tape from right to left.
77
77
7 : Stop playback or recording.
88
88
8 : Pause playback. To release it, press
33
33
3.
REC PAUSE : Press this button to enter recording pause.
Press this button and then
33
33
3 to start recording.
Operating Video Components
IMPORTANT:
To operate JVC’s video components using this remote control:
• Some JVC’s VCRs can accept two types of the control signals—
remote code “A” and “B.” Before using this remote control, make
sure that the remote control code of the VCR connected to the VCR
jacks is set to code “A.”
• Aim the remote control directly at the remote sensor on each
component, not on the receiver.
VCR
You can always perform following operations:
STANDBY/ON VCR :Turn on or off a VCR.
VCR CH +/– :Change the TV channels on the VCR.
After pressing VCR (source selecting button), you can use following
buttons for VCR operations:
33
33
3 : Start playback.
FF : Fast wind a tape.
REW : Rewind a tape.
77
77
7 : Stop playback or recording.
88
88
8 : Pause playback. To release it, press
33
33
3.
REC PAUSE : Press this button to enter recording pause.
Press this button and then
33
33
3 to start recording.
EN24-32.RX-6020V[J]_f 01.12.7, 11:34 AM29
To Next Page
Loading...
Need help?
General
