JVC RX-DV3SL - VCR connection; DBS tuner connection

RX-DV3SL
1-12
Prior to performing the following procedures, remove
the DVD / CD tray.
Remove the four screws marked A attaching the top
cover on the DVD / CD unit.
Pull the top cover toward the direction of the arrow
and draw the top cover toward the upper side.
Removing the the top cover
(See Fig.4)
Removing the tray drive motor board
(See Fig.5, 6)
Prior to performing the following procedures, remove
the DVD / CD tray, top cover, servo board and DVD /
CD unit.
Unsolder the solder points at the tray drive motor
board.
Detach the belt from the pulley on the bottom of the
DVD / CD unit. (Do not stain the belt with grease).
Remove the screws marked B attaching the tray
drive motor on the DVD / CD unit.
Remove the screws marked C attaching the tray
drive motor board on the DVD / CD unit.
1.
2.
1.
2.
3.
4.
DVD / CD unit
Fi
g
.6
Fig.4
Fig.5
A
A
A
A
B
Belt
Motor
C
Solder
points
Tray drive
motor board
DVD / CD unit
DVD / CD unit
Top cover
Stopper
Stopper
Motor
Pulley