JVC RX-DV3SL Service Manual

RX-DV3SL
1-6
Prior to performing the following procedures, remove
the top cover and rear panel.
Cut off the tie band fixing the harness.
Disconnect the DSP board from the connector
CN612 on the main board,
Disconnect the card wire frome the connecter CN614
on the main board.
Disconnect the S-video board from the connector
CN412 on the main board.
1.
2.
3.
4.
Removing each board connected to the
rear side of the main board
(See Fig.6 to 10)
Fig.6
Fig.7
Fig.8
DSP
board
Amplifier
board
Power
/Fuse
board
DSP board
CN412
CN201
CN612
CN241
CN212
CN612
Tuner
board
CN612
CN602
Tie
band
CN212
F
S-video
board
CN602
Amplifier board
CN212
G
CN231
CN241
DSP
board
S-video
board
Amplifier board
CN231
Fig.9
CN612
CN212
S-video
board
CN231
CN241
Fig.10
CN231
CN241
Main
board
CN212
CN612
CN412
Tuner
board
Amplifier board
Front panel assembly

JVC RX-DV3SL Specifications

General

Brand	JVC
Model	RX-DV3SL
Category	Receiver
Language	English