17
English
Tuner Operations
Setting the AM Tuner Interval Spacing
Some countries space AM stations 9 kHz apart, and other countries
use 10 kHz spacing.
• 9 kHz interval spacing is the initial setting.
On the front panel ONLY:
1
Turn off the unit.
• Be sure that the unit is plugged into a wall outlet.
2
Change the interval spacing.
To set the AM tuner to the 10 kHz spacing:
Hold down CONTROL 3 and press
STANDBY/ON.
“10k STEP” appears on the display for a while.
To set the AM tuner to the 9 kHz spacing:
Hold down CONTROL 2 and press
STANDBY/ON.
“9k STEP” appears on the display for a while.
The unit is turned on with the interval spacing changed.
From the remote control:
1
Press FM/AM.
2
Press repeatedly or hold TUNING 9 or ( until you find the
frequency you want.
• Pressing (or holding) TUNING 9 increases the frequencies.
• Pressing (or holding) TUNING ( decreases the frequencies.
Notes:
• When you hold and release CONTROL
3
(or TUNING
9
on the
remote control) or CONTROL
2
(or TUNING
(
on the remote
control), the frequency keeps changing until a certain station is
tuned in.
• When a station of sufficient signal strength is tuned in, the TUNED
indicator lights up on the display.
• When an FM stereo program is received, the STEREO indicator
also lights up.
Using Preset Tuning
Once a station is assigned to a channel number, the station can be
quickly tuned. You can preset up to 30 FM and 15 AM stations.
7 To store the preset stations
Before you start, remember...
There is a time limit in doing the following steps.
If the setting is canceled before you finish, start from step
2
again.
On the front panel ONLY:
1
Tune into the station you want to preset (see
“Tuning into Stations Manually”).
• If you want to store the FM reception mode for this station,
select the FM reception mode you want. See “Selecting the
FM Reception Mode” on page 18.
2
Press MEMORY.
The channel number position starts flashing on the
display for about 5 seconds.
3
Press CONTROL 3 (or 2) to select
a channel number while the channel
number position is flashing.
ANALOG
VOLUME
SPK.
MHz
TUNED STEREO AUTO MUTING
LR
ANALOG
VOLUME
SPK.
MHz
TUNED STEREO AUTO MUTING
LR
ANALOG
VOLUME
SPK.
MHz
TUNED STEREO AUTO MUTING
LR
Ex.: When selecting the FM band
Tuning into Stations Manually
On the front panel:
1
Press FM/AM to select the band.
The last received station of the selected band is
tuned in.
The CONTROL buttons now work for tuner
operations.
• Each time you press the button, the band alternates between
FM and AM.
2
Press CONTROL ∞ (or 5)
repeatedly until “< TUNING >”
appears on the display.
3
While “< TUNING >” still remains
on the display, press repeatedly or
hold CONTROL 3 (or 2) until you
find the frequency you want.
• Pressing (or holding) CONTROL 3 increases the frequencies.
• Pressing (or holding) CONTROL 2 decreases the frequencies.
ANALOG
VOLUME
SPK.
MHz
TUNED STEREO AUTO MUTING
LR
ANALOG
VOLUME
SPK. AUTO MUTING
LR
Ex. : When selecting the FM band
ANALOG
VOLUME
SPK.
MHz
AUTO MUTING
LR
EN15-18RX-DV3SL[UG]2.pm5 02.8.8, 2:21 PM17
To Next Page
Loading...
