1-8 (No.MB682<Rev.001>)
3.1.2 Removing the Front panel (see Fig.3 to 5)
(1) Disconnect the card wire from Front panel connected to
connector CN330
of the Micom board. (See fig.3)
(2) Remove the two screws D attaching the both side of Front
panel. (See Fig.4)
(3) Disengage two hooks a engaged Front panel. (See Fig.4)
(4) Remove the two screws E attaching the Front panel. (See
Fig.5)
(5) Disengage one hook b engaged Front panel. (See Fig.5)
Fig.3
Fig.4
Fig.5
3.1.3 Removing the Tuner pack (See Fig.6, 7)
(1) Disconnect the card wire from Tuner pack connected to
connector CN338
of the Micom board. (See Fig.6)
(2) Remove the two screws F attaching the Tuner pack. (See
Fig.7)
Fig.6
Fig.7
CN330
hook a
D
EE
hook b
CN338
F
To Next Page
Loading...
Need help?
General
