JVC UX-N5 - To Remove Usb Memory Device

Navigating the USB device from the main unit
Operation Main unit Remote control Note
Play
.
.
Press in the stop mode.
Stop
.
.
Press in the playback mode.
Pause
.
.
Press in the playback mode. Press the [I/W] button to resume
playback from the paused point.
Track up/down
.
.
Press in the playback or stop mode. If you press the button in
the stop mode, press the [I/W] button to start the desired track.
Fast forward/
reverse
.
.
Press and hold down in the playback mode. Release the button
to resume playback.
To remove USB memory device
1
To stop playback, press the [CD/USB o]
button on the remote control, or [o] on main
unit.
2
Disconnect the USB device from the USB/
iPad terminal.
.
Note
If USB memory device is not connected, “USB No
Media” will be shown on the display.
Caution
0
You cannot send any data from the unit to the USB
device.
0
It is recommended to use USB mass storage class
devices with 4 GB or less storage capacity.
0
Disable security function of the USB device.
0
When the source is set to “USB”, this unit starts
charring the battery of the USB device.
0
Disconnect the USB device after stopping playback.
Disconnecting the USB device during playback may
cause some problem of the USB device and its files.
0
We will not be held liable for the loss of data while
the USB memory device is connected to the audio
system. Please be noted in advance.
30