JVC VideoMovie GR-A30 - Connecting to a Television; Playback via RF Unit (No A;V Inputs)

17
CONNECTION TO A TELEVISION FOR PLAYBACK
The G R-A30U includes playback circuits and allows playback of pre-recorded cassettes simply by connecting to a
television set.
Connection to a television not equipped with audio/video input connectors
For this situation, use the RF-V3U RF unit (provided).
1
Matching transformer
(provided)
Antenna cable
(provided)
TV receiver
ANTENNA IN lvi oeo l OD
RF OUT
~
::r
I
--,,
Side view
To AV OUT
connector
CH3 CH4
: I Diil 1
1
• •
Set the output channel select switch of the
RF-V3U to CH 3 or CH4.
•The RF unit permits playback of video and
audio recordings through a TV receiver. The
signals from the RF unit are viewed through a
vacant channel not used for broadcasting in
your area.
•The RF unit has been set to CH3 prior to
shipment. Reset the channe l to CH4 (using a
screwdriver) in areas
where channel 3 is em -
ployed for broadcasting.
•This is your video channel. To view video
cassettes, always
set the TV channel selector
to either channel 3 or 4.
PRECAUTIONS FOR RF-V3U
•For exclusive use with the VideoMovie.
•Do not disassemble or remodel the RF-V3U.
•Do not expose it to strong shocks.
•Unplug the connected equipment during light-
ning storms.
(Never
touch the antenna cal be.)
To VHF
antenna terminal
RF-V3U
'------.-- .... (provided)
2 Remove the antenna cable from the TV receiver.
3
4
Connect the antenna cab le to the ANTENNA
IN terminal of the RF unit.
Connect the RF OUT terminal of the RF uni1
to the 75-ohm coaxial antenna terminal of the
TV receiver us ing the provided antenna cable.
To AV OUT
connector
Connect the VIDEO/ AUDIO INPUT cable of th1
RF unit to the AV OUT connector of the GR
A30U.