JVC XL-F115TN - Before Using for the First Time; COMPU LINK Connection

XL-F115TN/XL-F116BK
XL-F215TN/XL-F216BK
ny
BEFORE USING FOR THE FIRST TIME
COMPU LINK connection
JVC's COMPU LINK Remote Control System provides unified control
over system components connected with COMPU LINK. Connecting
JVC audio components with the COMPU LINK jacks automatically
controls relative operations between components and facilitates vari-
ous operations. With the COMPU LINK connection to an amplifier or
receiver, you Can operate XL-F215TN/XL-F1 15TN with the amplifier or
receiver's remote control unit. Synchronized recording is also avail-
able with this feature.
Connecting the COMPU LINK cord
:
The
COMPU
LINK-3
SYNCHRO
jacks
are
used
to
output
and
input
the
control
signal
for
the COMPU
LINK remote
control
system.
COMPU
LINK-compatible
products
are
provided
with
the
jacks marked
COMPU
LINK-1,
COMPU
LINK-2
or
COMPU
LINK-3,
referring
to
the
COMPU
LINK
version.
XL-F215TN/XL-F1
15TNis
equipped
with
COMPU
LINK-3.
You
can
connect
XL-F215TN/XL-F115TN
also
to
acomponent
with
lower
COMPU
LINK
versions.
But,
in
that
case,
only
the
lower
versions’
features
will
be
available.
:
Plug
the
supplied
COMPU
LINK
cord
into
the
COMPU
LINK-3
SYNCHRO
jack
on
the
rear
panel
of
XL-F215TN/XL-F115TN.
Piug
the
other
end
into
the
COMPU
LINK jack
of
the
other
component.
If there
are
two
€ “s COMPU LINK jacks, plug it into either of them.
Connecting the COMPU LINK system components with the COMPU
LINK cords
Supplied COMPU LINK cord
¢ Amplifier or receiver CD player Cassette deck Turntable
Page 6
(No. 20485) 1-9