JVC XL-F115TN User Manual

XL-F115TN/XL-F116BK
XL-F215TN/XL-F216BK
BASIC OPERATIONS
Basic functions for disc
playback
Turning on the power of this unit
Press the POWER switch to turn on this unit. The STANDBY
indicator is turned off and the display is turned on.
Main unit Remote control unit
POWER
Press again to turn off the power and activate the standby mode. The
STANDBY indicator is lit.
The power is automatically turned on also by;
@ Pressing the & OPEN/CLOSE button. ;
e Pressing the » PLAY/st PAUSE button on the main unit or the »
button on the remote control unit.
Notes
@ Asmail amount of power (4 watts) is consumed even in the standby
mode.
e Totum offthe powercompletely, disconnect the power cord from the
wall outlet.
Loading discs in the disc tray
Use the 4 OPEN/CLOSE button to open and close the disc tray.
Main unit Remote control unit
OPEN/CLOSE OPEN/
CLOSE
1. Open the disc tray by pressing the 4 OPEN/CLOSE button.
2. Place discs on the disc tray according to the groove with their
label side up.
3. Close the disc tray by pressing the 4 OPEN/CLOSE button.
CAUTION
When loading discs in the disc tray, be sure to put the discs
according to the groove. Otherwise, the discs will be dam-
aged when the disc tray is closed, and cannot be removed
from the unit.
Page 7
1-10 (No. 20485)
Remote control operation
(for XL-F215TN)
Point the remote control unit towards the REMOTE SENSOR and
operate it steadily and carefully. The remote control unit can be used
within a range of about 7 meters (23 feet) from the REMOTE SENSOR,
and at angles of up to about 30 degrees.
Playing a disc
Press the » PLAY/PAUSE button on the main unit or the > button
on the remote control unit.
Main unit Remote contro! unit
PLAY/PAUSE
=)
Pin
The » indicator lights on the display and playback starts.
To stop playback temporarily, press the » PLAY/i PAUSE button on
the main unit or the # button on the remote contro! unit.
The #1 indicator lights on the display and playback stops temporarily.
To resume playback, press the » PLAY/t# PAUSE button on the main
unit or the ® button on the remote control unit.
Adjusting the headphones ievel
Insert the headphones plug into the PHONES jack and turn the
PHONES LEVEL control to adjust the volume level.
Stopping playback
Press the m STOP/CANCEL button on the main unit or the @ button
on the remote contro! unit.
Main unit Remote control unit
STOP/CANCEL

JVC XL-F115TN Specifications

Power

power requirements	AC 120V ~, 60Hz
power consumption	18 watts

Audio Performance

frequency response	2 Hz to 20, 000 Hz (+1 dB)
dynamic range	More than 98.0 dB (at 1 kHz)
signal to noise ratio	More than 107.0 dB

Weight and Dimensions

dimensions	435 x 128 x 391 mm
weight	11.5 Ibs