XV-S300BK/XV-S332SL/XV-S402SL/XV-S403SG
17
3.2.2 For Jitter value
The jitter value is displayed on the FL display referring to the previous page.
The jitter value is displayed by the hexadecimal number.
In the following cases, please "Flap adjustment of the pick-up guide shaft" referring to the following page.
Before using the TEST disc VT-501, careful check it if there is neither damage nor dirt on the read surface.
Returns to a usual test mode by the thing to push the "STOP" button ot remote controller.
< In the following cases, please adjustment >
• When you exchange the pick-up
• When you exchange the spindle motor
• When the reading accuracy of the signal is bad (There is a block noise in the screen etc..)
Fig.3-3
POWER Button
DTS Display part
(Initialize complete)
FL Display
OPEN/CLOSE
Button(Test mode)
PLAY Button
(Test mode & display of jitter)
3D PHONIC
Button (Initialize start)
5 Button
(Laser of DVD)
4 Button
(Laser of CD)
To Next Page
Loading...
Need help?
General
