6
Wirings
In order to set the proper connections with the input and
output devices, a set of terminal connectors are provided
within the package.
Output Channel Configurations
The Kommander-KA02 output channels can be arranged
in multiple loudspeakers configurations. The following table
shows the maximum power delivered at the minimum load
impedance by each output channel according to the output
configuration.
Loudspeaker
Name
Loudspeaker load
impedance
Max number of
loudspeaker in
parallel per ch
Lyzard-KZ1 16 Ω 4
Lyzard-KZ14 16 Ω 4
Vyper-KV25 8 Ω 2
Tornado-KT2 8 Ω 2
Domino-KF26 8 Ω 2*
Truffle-KTR24 4 Ω 2**
Truffle-KTR25 4 Ω 2**
Truffle-KTR26 2 Ω 1**
RAIL 48 Ω 12*
* Not to full power
** 2ch Parallel Bridge-Tied Load – PBTL
CH1 CH2 CH3 CH4
SE 50 W @ 4 Ω SE 50 W @ 4 Ω SE 50 W @ 4 Ω SE 50 W @ 4 Ω
PBTL 100 W @ 2 Ω SE 50 W @ 4 Ω SE 50 W @ 4 Ω
PBTL 100 W @ 2 Ω PBTL 100 W @ 2 Ω
The following table shows the maximum number of K-array
loudspeaker that can be connected to a single output channel
according to the amplifier driving capabilities.
Kommander -KA02
User Guide
Audio Input
Balanced Audio Input
6 mm
(0.25 in)
6 mm
(0.25 in)
12 mm
(0.5 in)
Use only high quality speaker cables.
Wire gauges must comply with the loudspeaker
nominal impedance according to the cable run.
Ensure the amplifier’s minimum loading
impedance is matched, especially when
connecting multiple loudspeakers in parallel
Use only high quality signal cables
with proper grounding shield
12 mm
(0.5 in)
Speaker output
Speaker output
Parallel Bridge
Tied Load
PBTL
Single Ended
SE
To Next Page
Loading...
