To Next Page
J
John PageJul 30, 2025
What to do if K2 Pumps AWP00002K Water Pump plunger moves but no water is delivered?
- HhweaverJul 30, 2025
If the K2 Pumps Water Pump plunger is moving but no water is being delivered, there are several potential causes: 1. The pump may not be picking up prime. In this case, you should reprime the pump. 2. There might be a leak on the suction side, causing the suction pipe to suck air. Check the joints for leaks using soapy water. 3. The well could be gaseous, so consult the factory about installing a sleeve in the well. 4. The well might be experiencing intermittent over-pumping, where water is drawn down below the foot valve. If possible, lower the foot valve.
General
