Important: Please keep these instructions. The combination of this lock has
been factory preset: 2 and 4 pressed together, then 3.
WARNING
For your own safety, you must change the combination at the time of
installation.
PLEASE READ AND FOLLOW ALL DIRECTIONS CAREFULLY
Since every installation is unique, carefully check windows, frame, door, etc. to
ensure that the recommended procedures will not cause damage. KABA is not
responsible for any damage caused by installation.
Tools Required
•
1
⁄4" (6 mm) Drill Bit
• 1" (25 mm) Wood Chisel
•
3
⁄4" (19 mm) Hole Saw
• Phillips-head Screwdriver
• 1" (25 mm) Drill Bit or Hole Saw
• 1
5
⁄8" (41 mm) Hole Saw
Caution: Wear safety glasses when preparing door.
• 2 Pairs of Pliers
• Hacksaw
• Hammer
• Center Punch
• Drill (variable speed recommended)
To Next Page
Loading...
