Kaba C-lever - Page 6

6 k2evo704yy-2011-08 Kaba c-lever
EN
Quick Guide Installation
15
Install the locking cylinders (16) into
the mortise lock and fix it loosely with
the cylinder fixing screw (do not tigh-
ten).
Feed the antenna cable (15) through
the upper furniture fixing hole and
put the outside shield (1) onto the
door. After putting on the outside
shield (1) it is mandatory to pull the
spindle (5) in the direction of the
arrow, to relieve pressure from the
coupling unit (3).
NOTE: Take care of the antenna
cord (15)!
Push the coupling unit (3) with upper
part ahead into the outer shield (1).
Afterwards push the lower part of the
coupling unit (3) with the aid of a
screwdriver into the outer shield as
well. At the same time place the
antenna cable (15) in poaition as
shown in the sketch. The coupling
unit must be placed firmly and level in
the outer shield! Fix the coupling unit
with the fixing screw (11).
NOT:E: Do not bend the tabs in
the outer shield!