Kaba C-lever - Page 7

Installation Quick Guide
Kaba c-lever k2evo704yy-2011-08 7
EN
Put the inside plate (6) onto the
spindle (5) and locking cylinder (16)
and fasten it to the outside shield with
the two fixing screws (7).
Tightening torque: 2,5 ±0,5 Nm
Connect the antenna cord (15) to the
plug on the inside plate (6).
AT TENT ION: Printed circuit
boards can be damaged by
electrostatic discharge
especially by direct contact,
but also by indirect contact.
Always wear an suitable ESD
earthing strap when installing
or repairing equipment!
Insert the batteries (10) and put the
battery protection foil (8) between
them.
NOTE: Use lithium batteries
L91 R6 (AA) only!
Be sure the battery poles are
positioned correctly!